I pushed the Prusa Mini build volume to its limit to make a simple lamp shade for a pendant grow light setup I'm working on. There are a lot of things I'd change here - I think I need higher "refinement" when exporting a smooth geometric model like this from Fusion360, I should have told PrusaSlicer to align the "seam" all the way down one side of the print, and I need to find a way to diffuse the light a bit better to not show the structure of the bulb. I ended up going with a purchased lamp shade for this project for now, but the 3D print held up fine in daily use for a week or so before I found a lamp shade I like better on Amazon.